HP Pro 8500, 8500 DN, 8500 N manual Loading media in the optional tray

Loading media in the optional tray 4

N o t e

Before loading media into tray 4, verify that the spacers were removed from the tray when “Step 2: Unpacking the Printer” was performed.

1Firmly grip the handle in the center of the input tray, squeeze the release lever, and pull the tray out until it stops.

Depending on your country, tray 4 arrives adjusted for either A4- or letter- sized media. To load A4- or letter-sized media, proceed to step 5; otherwise, continue with step 2.

2Adjust the front guide by pulling up on the pin (A), placing the guide into the slots on the top and bottom of the tray that correspond to the media size you are loading (B), and pushing in the pin.

3Repeat step 2 to adjust the back guide.

4Repeat step 2 to adjust the left media guide.

N o t e

To load 11-by-17 inch media, rotate the left media guide 90°, move it to the back of the tray, and place it into the slots on the top and bottom of the tray that correspond to 11-by-17.

28 Step 7: Loading the Input Trays

EN