Table 6-1 Control-panel messages (continued)
Control panel message | Description | Recommended action | |
|
|
|
|
79.XXXX ERROR - To Continue Turn Off | A critical hardware error occurred. | 1. | Turn the device off, and then turn the |
Then On |
|
| device on. |
|
| 2. | If the problem persists, reseat the DIMM |
|
|
| on the formatter. |
|
| 3. | Remove and reinstall the formatter. |
|
| 4. | Upgrade the firmware. |
|
|
|
|
8X.YYYY EMBEDDED JETDIRECT ERROR | The embedded HP Jetdirect print server has | 1. | Turn the device off, and then turn the |
To continue turn off then on | encountered a critical error, as specified by |
| device on. |
| YYYY. | 2. | Turn the device off, reinstall the EIO |
|
| ||
|
|
| accessory, and then turn the device on. |
|
| 3. | Perform a RFU. |
|
| 4. | Replace the EIO formatter. |
|
| 5. | Remove the EIO accessory if one is |
|
|
| installed. |
99.XX.YY | (Errors 99.00.01 to 99.00.25) |
| This error occurs during a Remote Firmware |
| Upgrade (RFU). |
| The upgrade might have failed because of a |
| failing component or because the existing |
| firmware is the same as the firmware in the |
| RFU. |
1.Turn the device off, and then turn the device on.
2.Check to find out if an RFU is available. If it is, perform the RFU
3.If the RFU fails, check the description in the engine event log. The event log identifies the type of 99 error. If it is failing because the firmware is the latest available, an upgrade is not necessary and the error can be ignored.
4.Make sure that the formatter and output device connections are secure.
[FS] Device failure | The EIO hard disk had a critical failure and | 1. | Turn off the device. | |
| can no longer be used. | 2. | Remove and reinstall EIO hard disk. | |
|
|
| ||
|
|
| 3. | Turn the device on again. |
|
|
| 4. | If the error persists, replace the EIO |
|
|
|
| hard disk. |
|
|
|
| |
[FS] File operation failed | The requested operation could not be | 1. | Check the file name and try again. | |
| performed. You might have attempted an | 2. | Check the driver settings to see if any | |
| illegal operation, such as trying to download | |||
| a file to a nonexistent directory. |
| job retention features are selected. | |
|
|
| ||
[FS] File system if full | A PJL file system write command was | Resend the command. | ||
| received but could not be executed because |
|
| |
| one of the following devices was full: |
|
| |
| ● | ROM DISK |
|
|
| ● | RAM DISK |
|
|
| ● | CARD SLOT |
|
|
|
|
|
|
|
118 Chapter 6 Troubleshooting | ENWW |