●
●Service ID
NOTE: Make a note of the digital sender configuration information before performing an NVRAM initialization. Some configuration information will be lost.
To perform a partial NVRAM initialization
1.Turn off the digital sender.
2.Turn on the digital sender.
3.Immediately after turning on the device, press and hold down the #9 key (do not wait for the
4.Press the #3 key one time and then press Start.
5.Press the #3 key two times until the display reads NVRAM INIT.
6.Press the #6 key once to initiate the NVRAM initialization. The product will continue its
Disk initialization
The
The following items are deleted during a disk initialization:
●Local address books
●Downloaded Java™ applet files
To perform a disk initialization
1.Turn off the digital sender.
2.Turn on the digital sender.
3.Immediately after turning on the device, press and hold down the
4.Press the #5 key one time until INITIALIZE DISK appears.
5.Press the #6 key one time to initiate the disk initialization. The digital sender reboots.
ENWW |