Action: Your access point allows only a limited amount of time for you to complete the setup.
Start the setup process again and make sure to complete the setup in the time allowed.
●Error message: More than 1 SecureEasySetup access point found
Action: Someone else in the vicinity is also using SecureEasySetup to set up a device.
Cancel the setup and start over.
●Error message: Another device connected to the access point before the device tried connecting.
Action: Another device in the vicinity connected to your access point before the printer was able to connect.
Cancel the setup and start over.
●Error message: Low signal
Action: The access point is too far away or there is interference.
In order to establish a good signal between the printer and access point, you might have to experiment a bit. Assuming the equipment is functioning properly, try doing the following things separately or in combination:
–If there is a long distance between the computer or access point and the printer, move them closer.
–If a cordless telephone, microwave, or other device that emits radio signals transmitting at 2.4 GHz is nearby, move it farther away to reduce radio interference.
Network Guide | 19 |