HP R5500 manual Installing the ERM, Starting power to the load

Page 23

80 percent of their capacity within 3 hours

100 percent of their capacity within 48 hours

Starting power to the load

Start power to the load by placing the UPS in Operate mode (on page 26).

IMPORTANT: AC power must be available the first time the UPS is started.

Installing the ERM

Before installing the ERM, review and observe all warnings in "Precautions (on page 11)."

WARNING: Uneven mechanical loading in the rack may cause a hazardous condition.

CAUTION: Always plan the rack installation so that the heaviest item is on the bottom of the rack. Install the heaviest item first, and continue to populate the rack from the bottom to the top.

1.Install the mounting rails ("Installing the mounting rails" on page 13).

2.With one person on each side of the carton, lift the chassis and lower it to the floor in front of the rack.

3.Install the mounting ears on the chassis using the screws provided.

4.With one person on each side, lift the chassis to rail level and slide the chassis on the mounting rails.

5.Attach the chassis to the rack using the supplied screws.

6.If using the rear mounting brackets, be sure that the bracket tabs are fully inserted into the rear panel cutouts, then tighten the brackets.

Installation 23

Image 23
Contents HP UPS R5500 User Guide Audience assumptions Contents Spares Warranty information This section Component identificationUPS R5500 overview UPS front panelFront panel is shown with the bezel removed UPS front panel controlsUPS front panel LED indicators Repo port UPS rear panelERM rear panel Preparing to install the hardware InstallationPrecautions Readying the equipment Tools and materialsSelecting a site Installing the mounting rails Installation Preparing the rails for integrated shipping Installing the UPSRemoving the UPS battery bracket Installing the batteries Replacing the UPS battery bracket Installation Connecting the Repo port Installation Connecting devices to the UPS Connecting the ground bonding cableConnecting the UPS to utility power Installation Starting power to the load Installing the ERMInstallation Installation Modes of operation Standby modeOperate mode UPS operationsAuto-Bypass mode Configuring the UPSConfigure mode Silencing an audible alarm Testing the LEDsVerifying the Repo port connection Powering down the UPSPower management software Power managementRemoving the UPS front bezel MaintenanceMaintenance Replacing the UPS option card Replacing the batteries Important battery safety informationBattery care and storage guidelines Replacing the UPS UPS battery replacement procedureReplacing the ERM Updating the UPS firmware LED and audible alarm troubleshooting TroubleshootingBypass is out of range Battery conditionInsufficient warning of low batteries General alarm conditionInternal UPS fault condition Input voltage is out of rangeOverload condition Low battery shutdownsSite wiring condition UPS does not provide the expected backup timeUtility power condition UPS frequently switches between utility and battery powerUPS is in Auto-Bypass mode UPS is on batteryUPS input specifications SpecificationsUPS physical specifications ERM physical specificationsVoltage specifications UPS output specificationsPower protection specifications Output tolerance specifications Battery specificationsBattery runtime for NA/JPN model Battery runtime for Intl modelRepo port specifications Environmental specificationsOrdering spares UPS spare parts listSpares Hardware options HP contact information Technical supportBefore you contact HP Pre-Failure Battery Warranty Warranty informationLimited warranty $250,000 Computer Load Protection GuaranteeNotification from power management software FCC rating label Regulatory compliance noticesRegulatory compliance identification numbers Federal Communications Commission noticeClass B equipment Class a equipmentEuropean Union regulatory notice ModificationsCables Canadian notice Avis CanadienJapanese notice Bsmi notice Battery replacement notice Power cord statement for Japan Taiwan battery recycling noticeGrounding methods to prevent electrostatic discharge Electrostatic dischargePreventing electrostatic discharge Acronyms and abbreviations Index On button, location Operate mode Index
Related manuals
Manual 61 pages 14.43 Kb