HP R5500 manual Hardware options

Page 48

Item	Description	Spare part number

	Front bezel ERM	N/A

6	Cord retention clip (for C13 outlets only)	204505-001

7	UPS battery module	407419-001

8	Computer interface cable	397642-001

9	Extension bars and mounting hardware	419595-001*

10	UPS unit NA/JPN	407415-D71*

	UPS unit INTL	407416-B31*

11	ERM unit	407439-001*

12	10 A jumper cord	142258-006*

* not shown

Hardware options

For information on the supported hardware options, see the HP website (http://www.hp.com/go/rackandpower).

Spares 48

Image 48

Contents HP UPS R5500 User Guide Audience assumptions Contents Spares Warranty information Component identification UPS R5500 overviewUPS front panel This sectionUPS front panel controls Front panel is shown with the bezel removedUPS front panel LED indicators UPS rear panel Repo portERM rear panel Installation PrecautionsPreparing to install the hardware Tools and materials Selecting a siteReadying the equipment Installing the mounting rails Installation Installing the UPS Preparing the rails for integrated shippingRemoving the UPS battery bracket Installing the batteries Replacing the UPS battery bracket Installation Connecting the Repo port Installation Connecting the ground bonding cable Connecting the UPS to utility powerConnecting devices to the UPS Installation Installing the ERM Starting power to the loadInstallation Installation Standby mode Operate modeUPS operations Modes of operationConfiguring the UPS Configure modeAuto-Bypass mode Testing the LEDs Silencing an audible alarmPowering down the UPS Verifying the Repo port connectionPower management Power management softwareMaintenance Removing the UPS front bezelMaintenance Replacing the UPS option card Important battery safety information Battery care and storage guidelinesReplacing the batteries UPS battery replacement procedure Replacing the UPSReplacing the ERM Updating the UPS firmware Troubleshooting LED and audible alarm troubleshootingBattery condition Bypass is out of rangeGeneral alarm condition Internal UPS fault conditionInput voltage is out of range Insufficient warning of low batteriesLow battery shutdowns Site wiring conditionUPS does not provide the expected backup time Overload conditionUPS frequently switches between utility and battery power UPS is in Auto-Bypass modeUPS is on battery Utility power conditionSpecifications UPS physical specificationsERM physical specifications UPS input specificationsUPS output specifications Power protection specificationsVoltage specifications Battery specifications Battery runtime for NA/JPN modelBattery runtime for Intl model Output tolerance specificationsEnvironmental specifications Repo port specificationsUPS spare parts list SparesOrdering spares Hardware options Technical support Before you contact HPHP contact information Warranty information Limited warranty$250,000 Computer Load Protection Guarantee Pre-Failure Battery WarrantyNotification from power management software Regulatory compliance notices Regulatory compliance identification numbersFederal Communications Commission notice FCC rating labelClass a equipment Class B equipmentModifications CablesCanadian notice Avis Canadien European Union regulatory noticeJapanese notice Bsmi notice Battery replacement notice Taiwan battery recycling notice Power cord statement for JapanElectrostatic discharge Preventing electrostatic dischargeGrounding methods to prevent electrostatic discharge Acronyms and abbreviations Index On button, location Operate mode Index

Related manuals

Manual 61 pages 14.43 Kb