Manually Ejecting a Disc
If you need to eject a disc when the power is off, complete the following steps to eject the disc manually:
1.Make sure the power is off and any external power sources are disconnected.
2.Insert a small rod or pin, such as a paper clip (approximately 1/16 inch in diameter and at least 3/8 inch in length) into the Manual Eject Hole and push firmly as shown in the figure above.
3.Remove the disc from the tray.
4.Gently push the tray back into the drive until it locks into place.
PRESARIO MOBILE INTERNET PC BEYOND SETUP GUIDE | |
| 800 SERIES |