HP 1630 manual Power On Self Test Post, Running Post

Page 17

Maintenance & Service Guide

Presario 1600 Series Portable Computers

Notice Preface Home Product Description Troubleshooting Illustrated Parts Catalog

Removal & Replacement Procedures Specifications Connector Pin Assignments Battery Pack

Power On Self Test (POST)

Running POST

To run POST, complete the following steps:

Turn off the computer. Let stand for a 10 count, then turn the computer back on.

If POST does not detect any errors, the computer will not beep. This indicates successful completion of POST test. POST has run successfully and boots from the hard drive (or from a bootable diskette if one is installed in the diskette drive).

If POST detects errors, the errors are indicated by screen and/or audible messages. Refer to "Power-OnSelf-Test (POST) Codes" for a list of POST

codes and their relevant descriptions.

If the system is not functioning well enough to run POST, or if the display is not NOTE: functioning well enough to show POST error messages, refer to the Troubleshooting

tables.

Power-On Self-Test Messages

102 162 301 304 601 605 1780 1782

Probable Cause Recommended Action

102-System Board Failure

DMA, timers, etc.

Replace the system board.

 

162-System Options Not Set

Configuration incorrect

CMOS reflects that an invalid configuration has been set.

RAM failure

Memory test data error XX000YZZ RAM failure

Keyboard failure

Run Computer Setup.

Run Computer Setup.

1.Replace the memory modules.

2.Replace the system board.

1.Replace the memory modules.

2.Replace the system board.

Replace the system board.

301-Keyboard Error

1.Ensure the keys are not depressed during POST.

2.Reconnect the keyboard with the computer off.

3.Replace the keyboard.

304-Keyboard or System Unit Error

1. Replace the keyboard.

Keyboard or system board error 2. Replace the TouchPad or mouse. 3. Replace the system board.

601-Diskette Controller Error

Mismatch in drive type or failure in the

1.

Run Computer Checkup (TEST).

2.

Check and/or replace cables.

diskette controller

3.

Replace the system board.

 

605-Diskette Drive Error

Mismatch in drive type

Run Computer Setup.

1780-Primary Hard Drive 0 Failure

Disk 0 failed to respond Hard drive format error

1.Run Computer Checkup (TEST).

2.Replace the hard drive.

1.Run Computer Checkup (TEST).

2.Replace the hard drive.

1782-Hard Drive Controller

Hard drive controller failure

1.

Run Computer Setup.

2.

Replace the hard drive.

 

Back to top

Image 17
Contents Maintenance & Service Guide Maintenance and Service Guide Maintenance & Service GuidePreface SymbolsTechnician Notes Serial Number Locating Additional InformationCompaq Presario 1600 Series Portable Computers Product DescriptionTroubleshooting Illustrated Parts Catalog Serial Number Location Removal & Replacement ProcedureSerial Number Location Specifications Connector Pin Assignments Battery Pack Models Models & FeaturesFeatures Front of Unit Front of UnitLeft Side Components Left Side ComponentsRight Side Components Right Side ComponentsBottom Of Unit Clearing the Power-On Password DiagnosticClearing the Power-On Password Preliminary StepsRunning Post Power On Self Test PostBefore Replacing Parts Troubleshooting Without DiagnosticsSolving Keyboard/Numeric Keypad Problems Keyboard SolutionsSolving Minor Problems Solving Hard Drive Problems Probable Cause Solutions Hard Drive SolutionsSolving Hard Drive Problems Format a Diskette SolutionsSolving Audio Problems Probable Cause Solutions Solving Audio ProblemsProblem Solving Battery Pack and Battery Gauge Problems Solving Power Problems Power SolutionsSolving Power Problems Problem Probable Cause SolutionsSolving CD Drive Problems Probable Cause Solutions CD Drive SolutionsSolving CD Drive Problems Solving Hardware Installation Problems Hardware Installation SolutionsProblem Solving Memory Problems Probable Cause Solutions Memory SolutionsSolving Memory Problems Solving PC Card Problems PC Card SolutionsSolving PC Card Problems Probable Cause Solutions Global Settings tab,Solving Printer Problems Printer SolutionsSolving Touch Pad/Pointing Device Problems Cause Solutions Touch Pad SolutionsSolving Touch Pad/Pointing Device Problems Error Codes Description Spare Part Number System UnitLCD BoardsDisplay Mass Storage Devices Modem Cables Description Spare Part Number AC Power Cords Not Shown Description Spare Part NumberCables Return Kits Description Quantity Miscellaneous Hardware and ScrewsMiscellaneous Parts Description Spare Electrostatic Discharge Screws Service ConsiderationsTool and Software Requirements Speaker Assembly Cable Installation Cables and ConnectorsCable Positions Plastic PartsSequence ChartRemoving the Battery Pack Removing the Screws from the Palmrest Cover with Touch Pad Removing The Palmrest Cover with Touch PadRemoving the Palmrest Cover with Touch Pad Disconnecting the Palmrest Cover with Touch Pad Removing The Keyboard Removing the Keyboard Removing Screws and Heatspreader Removing The HeatspreaderReleasing and Removing the Status Panel Cover Removing The Status PanelBack to Preparing Computer for Disassembly Removing the Screws from the Interface Board Removing The Interface BoardMaintenance & Service Guide Removing the Interface Board with Header Attached Interface Board Components Interface Board Components Designator ConnectorInterface Board Removing The Hard Drive Disconnecting the Hard Drive Data Cable from the Hard Drive Board Removing The Battery Charger BoardRemoving the Screws and the Battery Charger Removing the Screws from the CD Drive Removing The CD DriveOpening the CD Drive Tray Releasing the Lever Disconnecting the CD Drive Cable from the CD Drive Hard Drive Removing the Hinge Covers Removing The Display AssemblyRemoving Screws from the Display Assembly Removing the Display Assembly with Flex Cable Attached Removing the Screws from the Plastic Subpanel Assembly Removing The Plastic Subpanel AssemblyReleasing the Plastic Subpanel Assembly Removing the Plastic Subpanel Assembly from the Chassis Removing The CD Drive Cable Disconnecting the CD Drive Cable from the System BoardRemoving the Screws from the CD Guide Support Bracket Removing The Speaker AssemblyCable routing Removing The Modem Assembly Removing the Modem from the ChassisDisconnecting the Modem Cable from the Modem Removing The Diskette Drive Disconnecting the Diskette Drive Cable from the System BoardRemoving the Diskette Drive Standoff Remove the Diskette Drive from the Chassis Removing The Fan Status Panel Removing the Screws and Audio Assembly Board Removing The Audio Assembly BoardRemoving The System Board Removing the Screws and Standoffs from System Board Maintenance & Service Guide Dip Switch System Board Settings Dip Switch SettingsCPU Core Voltage Setting Removing the Screw from the Memory Module Door Removing The Memory ModuleRemoving the Memory Module from the System Board Rear Connectors Rear ConnectorsSystem Overview Port ReplicatorPower Management Port Replicator Rear Connectors Port Replicator Rear ConnectorsPin Connectors
Related manuals
Manual 8 pages 26.72 Kb Manual 14 pages 60.01 Kb