HP N31.5 manual CD Transport Assembly

Page 24

1

2

3

4

1

CD Transport Assembly

1FINGER WELLS

These cutouts make it easy to grasp a CD by its edges when placing it on or removing it from the spindle. Both right-handed and left-handed users are accommodated by having both diagonals available.

LEVELLING SCREWS

For the best performance, the Nº31.5’s transport assembly should be level. Four levelling screws (one inside each finger well) allow you to adjust the transport assembly easily.

With the supplied 332" hex driver, and using the Nº31.5’s bubble level (3) as a gauge, adjust one or more of these screws to bring the transport assembly to level. To lower a corner, turn the corresponding screw clockwise; to raise a corner, turn the screw counterclockwise.

2SPINDLE

This is the device that spins the CD, and on which the CD rests during play. The CD must be centered on the spindle, and it must be clamped to the spindle by the disc damper.

24

Image 24
Contents Operating Manual Page Important Safety Instructions Table of Contents Introduction to Programming Unpacking and Placement Operating Voltage Frequency Quick Start… Warm up/break-in period Special Design Features Industrial Design Convenience Features Communications Links Setup and Installation Repeat this procedure for the other three spikes Connect a Digital Output to Your Processor Placement of Your Transport Insert Batteries in the Remote Control Front Panel See Top Panel Repeat A-B Program Review Top Panel Search Reverse Next CD Transport Assembly To overcome the magnet, you’ll need to give it a firm pull Display Infrared Receiver and Transmitter Remote Control SembliesNumeric Keypad No30 on No31, for example Miscellaneous Controls Battery Compartment Feet or less Rear Panel Class Laser ProductAC Power Cord Socket Digital OUTPUT, Eiaj Optical Basic Operation Page Page Page Introduction to Programming Delete Programming Advanced Programming Page Setting Options Available even without Linking Auto-Standby Madrigal Communications Link Linked amplifiers? you ask Conductor Source Component Link Cable Conductor Amp-Amp Link Cable Using Learning Remote Controls Place the Nº31.5 in ITS Front Panel Teaching Mode Operate Troubleshooting Linked Functions DON’T Work Care and Maintenance Canadian Warranty Obtaining Service Specifications Dimensions Installation Notes Page Madrigal Audio Laboratories, Inc. All rights reserved