HP N31.5 manual Basic Operation

Page 37

Loading a CD

Temporarily overriding a previously saved program

Playing all tracks in order

Beginning play with other than the first track

Replaying a track

Basic Operation

Before operating your Nº31.5, become familiar with its controls and their loca- tions. (See Front Panel, Top Panel, CD Transport Assembly, and Remote Control.)

To load a CD for play:

1.Make sure that the main power switch is set to the “” position.

2.Enable the Nº31.5’s controls by pressing standby.

3.Press Lid Open/Close to open the Lid.

4.Remove the Disc Damper from the spindle.

5.Place a CD onto the spindle, label side up. Handle the CD by the outer edges only.

6.Place the Damper on top of the CD. Make sure that it’s centered and seated securely.

7.Close the Lid by pressing Lid Open/Close again.

In a few seconds, the display will show the total number of tracks and their total playing time. The CD is now ready for play.

Note: If you have previously saved a program for the CD, the letter P will appear preceding the track number on the display. (See Programming.)

To override a previously saved program, press program clear; or on the Remote Control, press the 0 (zero) numbered key, then press prg/time. All of the CD’s tracks will be accessible for basic operation, but the program will still be retained in the Nº31.5’s memory.

To play all tracks on the CD, press the play button. All tracks will play in order. Play will stop automatically at the end of the CD.

To begin play with a track other than the first track:

1.Before pressing play, press next until the number of the desired track shows on the display (track + on the remote). If you pass the track you want to play, you can “back up” by pressing previous (track – on the remote). You may also select the track using the numbered buttons on the Remote Control.

2.Press play to begin playing that track. The remaining tracks will play in order. Play will stop automatically at the end of the CD.

To return to the beginning of a track while it’s playing, press play. Play will be suspended briefly, then that track will replay followed by the remaining tracks on the CD.

37

Image 37
Contents Operating Manual Page Important Safety Instructions Table of Contents Introduction to Programming Unpacking and Placement Operating Voltage Frequency Quick Start… Warm up/break-in period Special Design Features Industrial Design Convenience Features Communications Links Setup and Installation Repeat this procedure for the other three spikes Connect a Digital Output to Your Processor Placement of Your Transport Insert Batteries in the Remote Control Front Panel See Top Panel Repeat A-B Program Review Top Panel Search Reverse Next CD Transport Assembly To overcome the magnet, you’ll need to give it a firm pull Display Infrared Receiver and Transmitter Semblies Remote ControlNumeric Keypad No30 on No31, for example Miscellaneous Controls Battery Compartment Feet or less Class Laser Product Rear PanelAC Power Cord Socket Digital OUTPUT, Eiaj Optical Basic Operation Page Page Page Introduction to Programming Delete Programming Advanced Programming Page Setting Options Available even without Linking Auto-Standby Madrigal Communications Link Linked amplifiers? you ask Conductor Source Component Link Cable Conductor Amp-Amp Link Cable Using Learning Remote Controls Place the Nº31.5 in ITS Front Panel Teaching Mode Operate Troubleshooting Linked Functions DON’T Work Care and Maintenance Canadian Warranty Obtaining Service Specifications Dimensions Installation Notes Page Madrigal Audio Laboratories, Inc. All rights reserved