special commands table
Pressing repeat disc will advance you to the next command in the table; when you reach the end of the list, the Nº31.5 will return to the beginning. If no button is pushed for more than ten seconds, the Nº31.5 will “time out” and return to normal operation.
Command | Display |
positive “operate” | OPERATE |
|
|
positive “standby” | STANDBY |
|
|
positive “stop w/o moving lid” | STOP, NO LID |
|
|
positive “display intensity to off” | DISPLAY OFF |
|
|
positive “display intensity to medium” | DISPLAY MED |
|
|
positive “leave pause” | UNPAUSE |
|
|
positive “enter pause” | PAUSE |
|
|
positive “turn off repeat” | REPEAT OFF |
|
|
positive “turn on index mode” | INDEX ON |
|
|
positive “turn off index mode” | INDEX OFF |
|
|
positive “open lid” | OPEN LID |
|
|
positive “close lid” | CLOSE LID |
|
|
RANDOM PLAY | |
|
|
switch to | ANALOG MODE |
|
|
switch to | DIGITAL MODE |
|
|
4MOMENTARILY PRESS THE DISPLAY INTENSITY BUTTON TO TRANSMIT THE SELECTED IR CODE
Line up the IR window of your remote control with the right side of the display of the Nº31.5, at a distance of approximately
(If you are uncertain as to how to prepare your remote control for learning new commands, refer to the instructions provided with the remote control.)
5REPEAT THE PROCESS OF “TEACHING” NEW SPECIAL COMMANDS UNTIL ALL DESIRED COMMANDS HAVE BEEN LEARNED BY YOUR REMOTE CONTROL.
If you take longer than approximately ten seconds between button pushes, the Nº31.5 will time out and return to normal operation. If this occurs, re- turn to step #1 in this section. You may cycle through the entire list by pressing repeat disc repeatedly.
6WHEN FINISHED, RETURN TO NORMAL OPERATION BY ALLOWING THE Nº31.5 TO “TIME OUT”
The Nº31.5 will “timeout” and return to normal operation after approxi- mately ten seconds.
54