HP N31.5 manual Care and Maintenance

Page 57

Caution!

Care and Maintenance

To remove dust from the cabinet of the Nº31.5, use a feather duster. To remove dirt and fingerprints, we recommend isopropyl alcohol and a soft cloth.

Always apply the isopropyl alcohol to the soft cloth and then wipe the Nº31.5 with the dampened cloth. Never pour or spray even small amounts of any liquid directly on the Nº31.5, as doing so may allow the liquid to reach the circuitry inside the unit. Any liquid inside the unit poses a hazard to both the user and to the unit, and must be avoided.

Make sure that the Remote sensor window on the front panel and the Remote Control’s projection lens are kept clean and dust-free.

Fluorescent lighting and sunlight may interfere with the operation of the Remote Control. Avoid placing the Nº31.5 near fluorescent lamps or in direct sunlight.

When the Remote Control’s batteries need to be replaced, use only AA batteries; always replace both batteries at the same time. If you don’t plan to use the Re- mote Control often, remove the batteries. When not used for an extended period, even “leakproof” batteries can leak corrosive acids that will damage the Remote Control (and will void the warranty).

A CD, handled carefully, will last indefinitely. A warped, dusty, or scratched CD can cause playback problems, including audible skipping or other noises. Handle a CD by the outer edges only; if necessary, support it with your index finger at the center hole.

When you’re finished playing a CD, always return it to its plastic case. Store your CDs where they won’t be exposed to direct sunlight, high humidity, or extremely high or low temperatures.

57

Image 57
Contents Operating Manual Page Important Safety Instructions Table of Contents Introduction to Programming Unpacking and Placement Operating Voltage Frequency Quick Start… Warm up/break-in period Special Design Features Industrial Design Convenience Features Communications Links Setup and Installation Repeat this procedure for the other three spikes Connect a Digital Output to Your Processor Placement of Your Transport Insert Batteries in the Remote Control Front Panel See Top Panel Repeat A-B Program Review Top Panel Search Reverse Next CD Transport Assembly To overcome the magnet, you’ll need to give it a firm pull Display Infrared Receiver and Transmitter Semblies Remote ControlNumeric Keypad No30 on No31, for example Miscellaneous Controls Battery Compartment Feet or less Class Laser Product Rear PanelAC Power Cord Socket Digital OUTPUT, Eiaj Optical Basic Operation Page Page Page Introduction to Programming Delete Programming Advanced Programming Page Setting Options Available even without Linking Auto-Standby Madrigal Communications Link Linked amplifiers? you ask Conductor Source Component Link Cable Conductor Amp-Amp Link Cable Using Learning Remote Controls Place the Nº31.5 in ITS Front Panel Teaching Mode Operate Troubleshooting Linked Functions DON’T Work Care and Maintenance Canadian Warranty Obtaining Service Specifications Dimensions Installation Notes Page Madrigal Audio Laboratories, Inc. All rights reserved