HP N31.5 manual Warm up/break-in period

Page 9

Warm up/break-in period

5POWER UP THE REST OF THE SYSTEM, LEAVING THE POWER AMPLIFIERS FOR LAST

Always turn the power amplifier(s) off first, and on last. This good habit minimizes the opportunity for unexpected transients reaching your loud- speakers.

6SELECT THE INPUTS YOU ARE USING ON YOUR DIGITAL PROCESSOR AND PREAMPLIFIER

Take care that a Tape Monitor switch does not override your selection of the digital processor’s input on your preamplifier, or you will be struck by how “quiet” your new digital source is.…

7LOAD A DISC AND PRESS PLAY; SLOWLY RAISE THE VOLUME ON YOUR PREAMPLIFIER

Congratulations! You should now be able to enjoy your favorite music while reading the rest of this manual. (Please, do read the rest of this manual.)

Although your Mark Levinson Nº31.5 Reference CD Transport delivers outstanding performance straight out of the box, you should expect to hear it continue to im- prove as it reaches its normal operating temperatures and its various components “break-in.” For example, the pulse transformers* will not reach their ultimate per- formance until they have been driven with an actual load (meaning the digital output must be connected to something) for about 24 hours.

It has been our experience that the greatest changes occur within the first few hours as the Nº31.5 reaches thermal equilibrium. Depending on how cold the Nº31.5 was when you first connected it to AC power, full thermal equilibrium might take as long as a day or two, after which time its performance will remain quite constant.

The only exception to this rule is if power is removed from the unit for more than a few minutes, allowing it to cool down. Depending on the degree of cool- ing involved, you should expect a brief warm-up period before the Nº31.5’s sound quality is at its best. Unless your Nº31.5 was allowed to become quite chilled, subsequent thermal re-stabilization should not take long.

*Pulse transformers couple the internal digital circuitry to the actual connector on the rear panel. The ones used in your Nº31.5 are costly and offer extraordi- nary performance. Even so, they exhibit this modest “break in” period during which they improve beyond their initial performance.

9

Image 9
Contents Operating Manual Page Important Safety Instructions Table of Contents Introduction to Programming Unpacking and Placement Operating Voltage Frequency Quick Start… Warm up/break-in period Special Design Features Industrial Design Convenience Features Communications Links Setup and Installation Repeat this procedure for the other three spikes Connect a Digital Output to Your Processor Placement of Your Transport Insert Batteries in the Remote Control Front Panel See Top Panel Repeat A-B Program Review Top Panel Search Reverse Next CD Transport Assembly To overcome the magnet, you’ll need to give it a firm pull Display Infrared Receiver and Transmitter Semblies Remote ControlNumeric Keypad No30 on No31, for example Miscellaneous Controls Battery Compartment Feet or less Class Laser Product Rear PanelAC Power Cord Socket Digital OUTPUT, Eiaj Optical Basic Operation Page Page Page Introduction to Programming Delete Programming Advanced Programming Page Setting Options Available even without Linking Auto-Standby Madrigal Communications Link Linked amplifiers? you ask Conductor Source Component Link Cable Conductor Amp-Amp Link Cable Using Learning Remote Controls Place the Nº31.5 in ITS Front Panel Teaching Mode Operate Troubleshooting Linked Functions DON’T Work Care and Maintenance Canadian Warranty Obtaining Service Specifications Dimensions Installation Notes Page Madrigal Audio Laboratories, Inc. All rights reserved