HP N31.5 manual Important Safety Instructions

Page 3

Important Safety Instructions

Please read all instructions and precautions carefully and completely before operating your Mark Levinson com- ponent.

1.ALWAYS disconnect your entire system from the AC mains before connecting or disconnecting any cables, or when cleaning any component.

2.This product is equipped with a three-conductor AC mains power cord which includes an earth ground connection. To prevent shock hazard, all three connections must ALWAYS be used. If your electrical outlets will not accept this type of plug, an adapter may be purchased. If an adapter is necessary, be sure it is an approved type and is used properly, supplying an earth ground. If you are not sure of the integrity of your home electrical system, contact a li- censed electrician for assistance.

3.ALWAYS keep electrical equipment out of the reach of children.

4.AC extension cords are not recommended for use with this product. If an extension cord must be used, be sure it is an approved type and has sufficient current-carrying capacity to power this product.

5.NEVER use flammable or combustible chemicals for cleaning audio components.

6.NEVER operate this product with any covers removed.

7.NEVER wet the inside of this product with any liquid.

8.NEVER pour or spill liquids directly onto this unit.

9.NEVER block air flow through ventilation slots or heatsinks.

10.NEVER bypass any fuse.

11.NEVER replace any fuse with a value or type other than those specified.

12.NEVER attempt to repair this product. If a problem occurs, contact your Mark Levinson® dealer.

13.NEVER expose this product to extremely high or low temperatures.

14.NEVER operate this product in an explosive atmosphere.

15.ALWAYS unplug sensitive electronic equipment during lightning storms.

Image 3
Contents Operating Manual Page Important Safety Instructions Table of Contents Introduction to Programming Unpacking and Placement Operating Voltage Frequency Quick Start… Warm up/break-in period Special Design Features Industrial Design Convenience Features Communications Links Setup and Installation Repeat this procedure for the other three spikes Connect a Digital Output to Your Processor Placement of Your Transport Insert Batteries in the Remote Control Front Panel See Top Panel Repeat A-B Program Review Top Panel Search Reverse Next CD Transport Assembly To overcome the magnet, you’ll need to give it a firm pull Display Infrared Receiver and Transmitter Semblies Remote ControlNumeric Keypad No30 on No31, for example Miscellaneous Controls Battery Compartment Feet or less Class Laser Product Rear PanelAC Power Cord Socket Digital OUTPUT, Eiaj Optical Basic Operation Page Page Page Introduction to Programming Delete Programming Advanced Programming Page Setting Options Available even without Linking Auto-Standby Madrigal Communications Link Linked amplifiers? you ask Conductor Source Component Link Cable Conductor Amp-Amp Link Cable Using Learning Remote Controls Place the Nº31.5 in ITS Front Panel Teaching Mode Operate Troubleshooting Linked Functions DON’T Work Care and Maintenance Canadian Warranty Obtaining Service Specifications Dimensions Installation Notes Page Madrigal Audio Laboratories, Inc. All rights reserved