9.Remove the roll from the printer, pulling out the end on the right side of the printer first. Do not insert your fingers into the spindle supports during the removal process.
10.To remove the roll from the printer after you have unloaded the
The edge holders
The edge holders are designed to prevent the edges of the substrate from rising while printing is in progress. They are recommended for textile and
If you choose to use them, you should place them on the platen when prompted by the front panel (this prompt appears when using the loading accessory). Open the window, place the edge holders, then close the window.
WARNING! Do not touch the printer's drying enclosure. Even after you have opened the window latch, which disconnects the power to the drying and curing modules, the internal surfaces could be hot.
The edge holders should be placed on the platen so that they slightly overlap the left and right edges of the substrate. The edge holders fit into holes in the platen, and they are magnetic, which helps them to stay in place.
Handle the substrate
Slide the edge holder to the left or right with your fingers so that you can see the edge of the substrate in the two square holes in the side of the edge holder.
ENWW | The edge holders 49 |