HP ZT1100 manual Additional Steps

Component

PCA, volume control

Saddles, hinge

Socket, PCMCIA

Speaker, left

Speaker, right

Tray, hard disk drive

Removal Procedure

Keyboard cover (page 2-9).

Keyboard (page 2-11).

Display assembly (page 2-18).

Top case (page 2-27).

Hinge saddle, right (page 2-30).

See page 2-30.

Plug-in module (page 2-5).

Hard disk drive (page 2-6).

Keyboard cover (page 2-9).

Keyboard (page 2-11).

SDRAM modules (page 2-13).

Mini-PCI card (page 2-16).

Display assembly (page 2-18).

Fan and heatsink (page 2-22).

CPU module (page 2-25).

Top case (page 2-27).

Hinge saddles (page 2-30).

Motherboard (page 2-32).

Keyboard cover (page 2-9).

Keyboard cover (page 2-9).

Keyboard (page 2-11).

See page 2-7.

Additional Steps

Carefully lift the PCA off of its connector and out of the notebook.

Reassembly Notes: Make sure the headphone jack fits through its opening in the bottom case, and that the PCA is set securely on its connector.

Remove the four screws (M2x3.5) attaching the PCMCIA socket to the motherboard, and remove the socket.

Remove the retaining screw from the speaker. Disconnect the speaker wires from the motherboard, and lift the speaker out of the notebook.

Reassembly Notes: Make sure the tabs on the left side of the speaker fit between the corresponding tabs in the bottom case, and the speaker wire fits through its notch in the bottom case.

Remove the retaining screw from the speaker. Disconnect the speaker wires from the motherboard, and lift the speaker out of the notebook.

Reassembly Notes: Make sure the tab at the right rear of the speaker fits under the corresponding tab in the bottom case, and the speaker wire fits through its notch in the bottom case.

HP Pavilion zt1100/xz100 Omnibook xt1000 Removal and Replacement 2-39