HP ZT1100 manual Removing the System Sdram Module, Installing an Expansion Sdram Module

Reassembly Notes

•Carefully press the SDRAM module into the connector at an angle of about 30°, until it is fully inserted. Then press down on both sides of the module until the latches snap closed.

Figure 2-11. Installing an Expansion SDRAM Module

Removing the System SDRAM Module

Removal Procedure

1.Unplug the AC adapter, if present, and remove the battery.

2.Remove the keyboard cover (page 2-9).

3.Open the keyboard (page 2-11, steps 1 though 4). You don’t need to disconnect the keyboard cable.

4.Press outward to release the latches at the sides of the SDRAM module (so that the free edge of the module pops up), then pull the module out of the connector.

Figure 2-12. Removing the System SDRAM Module

Reassembly Notes

•Carefully press the SDRAM module into the connector at an angle of about 30°, until it is fully inserted. Then press down on both sides of the module until the latches snap closed.

2-14 Removal and Replacement HP Pavilion zt1100/xz100 Omnibook xt1000