Screws, M2.5×6mm (4)
Label with DIP switch settings
Screws, M2.5×6mm (2)
Screws,
M2.5×6mm (5)
Figure 2-10. Removing the Display
Reassembly Notes
∙Before installing any screws, make sure the center hinge cover fits over the tab in the bottom case.
Important
∙Make sure the DIP switches on the display interface PCA match the settings shown on the label on the display cable, or you risk damaging the display.
∙If you change the DIP switches, you must also reprogram the EEPROM for the new display— see page
HP OmniBook 6000 |