HP 4100 manual Removing a RAM Board, RAM Board Replacement Part Numbers, Description Part Number

Removing a RAM Board

(User-Replaceable)

	Table 2-4. RAM Board Replacement Part Numbers
Description		Part Number
RAM board, 32-MB		1818-7413
RAM board, 64-MB		1818-7414

Exchange Part Number

F1456-69100

F1457-69100

Caution

Handle the RAM board only by its edges and provide proper grounding. Otherwise, you may damage the board due to electrostatic discharge.

Required Equipment

∙Small Phillips screwdriver.

Removal Procedure

1.Unplug the ac adapter, if present, and remove the battery.

2.Turn the unit bottom side up, then remove the two screws from the RAM/BIOS cover and remove the cover.

3.Release the two latches at the sides of the RAM board, so the free edge of the board pops up.

4.Pull the board out of the connector.

Figure 2-2. Removing a RAM Board

Reassembly Notes

∙Insert the RAM board into the connector at about a 30° angle until it is fully inserted. Then press down at both sides until both latches snap closed.

2-4 Removal and Replacement HP OmniBook 4100