6.Remove the two screws holding the LCD brackets and hinges near the bottom corners of the display case. Remove the combined hinges and strip cover.
7.On the plastic cable holder, unsnap the cover.
8.If present, unplug the flex cable that wraps around the inverter PCA to the left of the cable holder.
9.Raise the inverter PCA out of the case and unplug the three cables. Remove the PCA.
10.Slide the LCD module and brackets toward the bottom of the case. When the slots in the brackets clear the tabs in the case, lift out the LCD
11.If the LED strip cable is held by the LCD bracket, lift the right tab of the LED strip where it fits into the display case. Lift the strip out of the case.
12.Remove the four screws holding the brackets to the LCD module.
13.Separate the LCD module and the shield:
∙You may have to remove one or more pieces of tape.
∙If the flex cable is still attached to the LCD module, unplug the cable.
| HP OmniBook 4100 |