HP 4100 manual Removing the Display Assembly

Removing the Display Assembly

(HP Authorized Service Providers Only)

Required Equipment

∙Small Phillips screwdriver.

Removal Procedure

1.Unplug the ac adapter, if present, and remove the battery.

2.On the back of the unit, lift up on the VGA connector cover above the VGA port and unsnap it from the case.

3.Remove the screw above the VGA port.

4.Remove the four “D” screws from the bottom case.

5.Open the display about 90 degrees, then lift off and lay back the combined top-case strip cover and display assembly.

6.Remove the two screws from the LCD flex cable end and unplug the cable.

Caution:

Install new screws after removing the two 16mm screws at the corners.

Screw, M2.5×16mm (2)

Screw, M2×4mm

Strip cover

LCD flex cable

Screw, M2.5×5mm

(1)

VGA connector cover

Screw, M2.5×5mm

Screw, M2.5×19mm

(2)

Figure 2-6. Removing the Display

2-10 Removal and Replacement HP OmniBook 4100