3.While holding the paper label in place, attach a serial label overlay into the outer recess. It covers and protects the serial label.
Removing the BIOS IC
(HP Authorized Service Providers Only)
Note
A replacement BIOS IC contains only enough basic programming to boot the OmniBook. After installing the IC, you must reprogram it.
Required Equipment
∙Small Phillips screwdriver.
∙IC insertion/removal tool.
Removal Procedure
1.Unplug the ac adapter, if present, and remove the battery.
2.On the bottom of the unit, remove the two screws from the RAM/BIOS cover and remove the cover.
3.Use an IC insertion/removal tool to remove the BIOS IC from its socket.
IC insertion/removal tool
Figure 2-12. Removing the BIOS IC
| HP OmniBook 4100 |