Using the First-Time Setup Wizard
Initial Setup
When turning on the TV for the first time, it automatically memorizes the broadcasting channels where you live. Perform the following steps before you press TV Power on the remote control unit.
1Insert the batteries into the remote control unit.
2Connect the antenna cable to the TV.
3Plug in the AC cord to the AC outlet.
Language setting
n
When the CableCARD is inserted, power consumption is higher.
Antenna setting
1Press the left arrow and right arrow buttons on the remote control to select Air or Cable for analog. Then press the down arrow button to move down.
Using the
1Select from among three languages: English, French, and Spanish.
2Press the up arrow and down arrow buttons on the remote control to select the desired language listed on the screen, and then press Select.
2Press the left arrow and right arrow buttons to select Standard, HRC, or IRC for digital (cable).
3Press Select to enter the setting.
■This operation makes the TV search for both analog and digital (cable).
Standby mode setting
Select the standby mode setting.
■Mode 1: Starting TV is quick from standby.
■Mode 2: Power consumption is small when in standby.
Language |
|
Standby Mode |
|
Air/Cable | Mode 1 |
CH Search | Mode 2 |
|
■There are three types of CATV systems, including Standard, HRC, and IRC. Select the one that matches your TV.
n
Digital (cable) setting cannot be selected when a proper CableCARD is inserted.
Channel search
Channel search automatically searches for a signal from all channels in the area.
1Press the left arrow and right arrow buttons on the remote control to select Yes or No for Analog, and then press the down button to move down.