HP R817 manual Using the Burst Setting, Press , use the buttons to highlight Burst , then press

Using the Burst Setting

Burst allows you to take two or more pictures (depending on available memory space) as quickly as possible when you press and hold the Shutter button all the way down.

1.Press , use the buttons to highlight Burst , then press .

2.Frame the subject and press the Shutter button halfway down to lock the focus and exposure. Then press the Shutter button all the way down and hold it. The camera takes pictures as quickly as possible until you release the Shutter button or the camera runs out of memory.

The Image Display remains off during the burst capture. After the burst images have been taken, each image appears one at a time in Instant Review (see page 117). You can delete the images during Instant Review by pressing , then selecting Entire Burst Sequence in the Delete sub-menu.

The Burst setting remains in effect until it is changed again, or until it resets to the default Timer Off setting when you turn the camera off. To save changed settings, use My Mode (see page 56).

NOTE: The Burst setting is not available while recording video clips nor in Panorama or Document shooting modes. You also cannot record audio when using the Burst setting, but you can add an audio clip later (see page 96). Also, the flash is not available while using the Burst setting.

NOTE: If you have set Bracketing (see page 66) with Burst, the camera captures a set of three images using the settings you specified in Bracketing.

Taking Pictures and Recording Video Clips 61