HP dc5850 manual Resetting the Password Jumper

Page 64

Resetting the Password Jumper

To disable the power-on or setup password features, or to clear the power-on or setup passwords, complete the following steps:

1.Shut down the operating system properly, then turn off the computer and any external devices, and disconnect the power cord from the power outlet.

2.With the power cord disconnected, press the power button again to drain the system of any residual power.

WARNING! To reduce the risk of personal injury from electrical shock and/or hot surfaces, be sure to disconnect the power cord from the wall outlet, and allow the internal system components to cool before touching.

CAUTION: When the computer is plugged in, the power supply always has voltage applied to the system board even when the unit is turned off. Failure to disconnect the power cord can result in damage to the system.

Static electricity can damage the electronic components of the computer or optional equipment. Before beginning these procedures, ensure that you are discharged of static electricity by briefly touching a grounded metal object. See the Hardware Reference Guide for more information.

3.Remove the computer cover or access panel.

4.Locate the header and jumper.

NOTE: The password jumper is green so that it can be easily identified. For assistance locating the password jumper and other system board components, see the Illustrated Parts Map (IPM) for that particular system. The IPM can be downloaded from http://www.hp.com/support.

5.Remove the jumper from pins 1 and 2. Place the jumper on either pin 1 or 2, but not both, so that it does not get lost.

6.Replace the computer cover or access panel.

7.Reconnect the external equipment.

8.Plug in the computer and turn on power. Allow the operating system to start. This clears the current passwords and disables the password features.

9.To establish new passwords, repeat steps 1 through 4, replace the password jumper on pins 1 and 2, then repeat steps 6 through 8. Establish the new passwords in Computer Setup. Refer to the Computer Setup (F10) Utility Guide for Computer Setup instructions.

58 Appendix B Password Security and Resetting CMOS

ENWW

Image 64
Contents Troubleshooting Guide dc5850 Models Troubleshooting Guide Iii Iv About This Book Table of contents Appendix B Password Security and Resetting Cmos Accessing DPS Through Computer SetupHP Insight Diagnostics HP Insight DiagnosticsSurvey Tab Test Tab Log Tab Select a language and click Download Protecting the SoftwareProtecting the Software HP Backup and Recovery Manager Safety and Comfort Before You Call for Technical Support Safety and ComfortHelpful Hints Helpful Hints 1Solving General Problems Solving General ProblemsComputer date and time display is incorrect Cause Solution There is no sound or sound volume is too low Cause Solution Solving General ProblemsPoor performance is experienced Cause Solution Cause Solution Enww 2Solving Power Problems Solving Power ProblemsPower supply shuts down intermittently Cause Solution Solving Diskette Problems Solving Diskette Problems3Solving Diskette Problems Cannot format diskette Cause Solution Problem has occurred with a disk transaction Cause SolutionDiskette drive cannot read a diskette Cause Solution Invalid system disk message is displayed Cause SolutionStorage Boot Order BootSecurity Password Options Storage Storage Options Removable MediaSolving Hard Drive Problems 4Solving Hard Drive ProblemsHard drive error occurs Cause Solution Disk transaction problem Cause SolutionSolving Hard Drive Problems Nonsystem disk/NTLDR missing message Cause SolutionStorage Boot Order list Computer will not boot from hard drive Cause SolutionComputer seems to be locked up Cause Solution Solving Media Card Reader Problems Solving Media Card Reader Problems5Solving Media Card Reader Problems Can not write to the media card Cause SolutionEnww Solving Display Problems Solving Display Problems6Solving Display Problems Blank screen no video Cause SolutionDim characters Cause Solution Install the video drivers included in the upgrade kit Image is not centered Cause SolutionOut of Range displays on screen Cause Solution Select ImageControl/ Horizontal Position or VerticalCertain typed symbols do not appear correct Cause Solution Solving Audio Problems Solving Audio Problems7Solving Audio Problems Sound cuts in and out Cause SolutionLine-in jack is not functioning properly Cause Solution Unsaved dataSolving Printer Problems Solving Printer Problems8Solving Printer Problems Solving Keyboard and Mouse Problems 9Solving Keyboard Problems10Solving Mouse Problems Select Shut DownSolving Keyboard and Mouse Problems 11Solving Hardware Installation Problems Solving Hardware Installation ProblemsComputer will not start Cause Solution Solving Hardware Installation Problems Goes awayOnce bad card is identified, remove and replace bad Option card12Solving Network Problems Solving Network ProblemsWake-on-LAN feature is not functioning Cause Solution Network status link light never flashes Cause Solution Solving Network ProblemsDiagnostics reports a failure Cause Solution New network card will not boot Cause Solution Drivers for a new expansion board were installedNetwork controller requires drivers Solving Memory Problems Solving Memory Problems13Solving Memory Problems Enww Solving Processor Problems Solving Processor Problems14Solving Processor Problems Some fans only operate when needed15Solving CD-ROM and DVD Problems Solving CD-ROM and DVD ProblemsMode in Security Password Options Movie will not play in the DVD drive Cause Solution Solving CD-ROM and DVD ProblemsCannot eject compact disc tray-load unit Cause Solution Solving Drive Key Problems 16Solving Drive Key ProblemsUSB Drive Key not found identified Cause Solution System will not boot from USB Drive Key Cause SolutionSolving Front Panel Component Problems Solving Front Panel Component Problems17Solving Front Panel Component Problems 18Solving Internet Access Problems Solving Internet Access ProblemsUnable to connect to the Internet Cause Solution Solving Internet Access Problems Click on System and MaintenanceDouble-clickAgere Systems PCI-SV92PP Soft ModemSolving Software Problems 19Solving Software ProblemsContacting Customer Support Contacting Customer SupportPost Error Messages Post Numeric Codes and Text Messages Post Numeric Codes and Text MessagesTable A-1Numeric Codes and Text Messages Control panel message Description Recommended actionIf the error persists after replacing Memory modulesMemory modules, replace the system BoardFlash Screen Image Corrupted Flash Screen image has errors Clear CMOS. See Appendix BVerify monitor is attached and turned Replace the graphics card if possibleUnder Storage DPS Self-test Enww Activity Beeps Possible Cause Recommended Action Table A-2Diagnostic Front Panel LEDs and Audible CodesIs not spinning, make sure the fans cable is This procedure until failure occurs. Replace Device that is causing the failure Replace one device at a time and repeat Continue adding devices one at a time toCheck that both power supply cables are Problem persists, replace the system boardProperly connected to the system board Check to see if the 5Vaux light onCmos Resetting the Password Jumper Clearing and Resetting the Cmos Using Computer Setup to Reset CmosLocate, press, and hold the Cmos button in for five seconds Figure B-1 Cmos buttonDrive Protection System DPS Accessing DPS Through Computer Setup Select Storage DPS Self-TestIndex Index
Related manuals
Manual 4 pages 1.09 Kb Manual 19 pages 40.13 Kb Manual 114 pages 23.07 Kb