HP 510 manual Choose the paper tray and set the paper type, Set the paper size

hp digital copier series

choose the paper tray and set the paper type

If you have installed the optional 250-sheet plain paper tray, it becomes the default paper tray used for copying. To use a type of paper other than plain paper, such as transparency film, load that paper in the main tray. Adjust the settings for paper type to ensure the best quality and specify which paper tray to use.

Caution! You must have the two-sided printing accessory installed to use the 250-sheet plain paper tray.

When you change copy settings on the front panel, the settings are reset to the defaults two minutes after the unit completes the copy job.

HP recommends adjusting paper type settings for the type of paper you’re using.

1Press Tray Select/Paper Type.

2If you have both paper trays, press Tray Select/Paper Type until the desired paper tray is selected, as indicated by the dot on the left.

3When copying from the main tray, press until the appropriate paper type appears.

4Press Enter to choose the displayed paper type.

set the paper size

To modify paper size:

1Press Menu.

2Press 1, then press 2.

This selects Copy Setup, then selects Paper Size.

3If you have the optional 250-sheet paper tray installed, press and

to select the upper or lower tray, then press Enter to select.

4Press until the desired size appears, then press Enter to select it.

load paper and originals 13