HP 510 specification

All rights are reserved. No part of the document may be photocopied, reproduced, or translated to another language without the prior written consent of Hewlett-Packard Company.

Publication number: C7296-90280

First edition: January 2002

Printed in U.S.A., Mexico, Germany, Singapore, or China

Windows®, Windows NT®, Windows ME®, Windows XP®,

and Windows 2000® are U.S.-registered trademarks of Microsoft Corporation.

Intel® and Pentium® are registered trademarks of Intel Corporation.

notice

The information contained in this document is subject to change without notice and should not be construed as a commitment by the Hewlett-Packard Company.

Hewlett-Packard assumes no responsibility for any errors that may appear in this document, nor does it make expressed or implied warranty of any kind with regard to this material, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose.

The Hewlett-Packard Company shall not be liable for incidental or consequential damages in connection with, or arising out of the furnishing, performance, or use of this document and the program material which it describes.

Note: Regulatory information can be found in the “Technical information” section of the Support and Specifications Booklet.

It is not lawful in many places to make copies of the following items. When in doubt, check with a legal representative first.

•Governmental paper or documents:

-Passports

-Immigration papers

-Selective service papers

-Identification badges, cards, or insignias

•Governmental stamps:

-Postage stamps

-Food stamps

•Checks or drafts drawn on Governmental agencies

•Paper currency, traveler’s checks, or money orders

•Certificates of deposit

•Copyrighted works safety information

Warning! To prevent fire or shock hazard, do not expose this product to rain or any type of moisture.

Always follow basic safety precautions when using this product to reduce risk of injury from fire or electric shock.

WARNING: potential shock hazard

1Read and understand all instructions in the setup poster.

2Use only a grounded electrical outlet when connecting the unit to a power source. If you do not know whether the outlet is grounded, check with a qualified electrician.

3Observe all warnings and instructions marked on the product.

4Unplug this product from wall outlets before cleaning.

5Do not install or use this product near water or when you are wet.

6Install the product securely on a stable surface.

7Install the product in a protected location where no one can step on or trip over the line cord, and where the line cord will not be damaged.

8If the product does not operate normally, see the online Troubleshooting help.

9No operator-serviceable parts inside. Refer servicing to qualified service personnel.

10Use in a well-ventilated area.