HP 510 manual Make a copy, Increase copy speed or quality Reduce or enlarge a copy, Edges

hp digital copier series
make a copy	1	Load your original on the glass or into the ADF, if available. If you are
		placing your original on the glass, open the lid of your HP Digital
		Copier and place the document face down in the bottom-right corner
		of the glass with the sides of the picture touching the right and bottom
		edges.
	2	Press Start Copy - Black or Start Copy - Color.

top edge of original

increase copy speed or quality

reduce or enlarge a copy

The HP Digital Copier has three settings that determine copy speed and quality.

•Best produces the highest quality for all paper and eliminates the banding (striping) effect that sometimes occurs in solid areas. Best copies more slowly than the other quality settings.

•Normal delivers high-quality output and is the recommended setting for most of your copying. Normal copies faster than Best.

•Fast copies faster than the Normal setting. The text is of comparable quality to the Normal setting, but the graphics may be of lower quality. Using Fast also cuts down on the frequency of replacing your ink cartridges, because it uses less ink.

to change the quality of your copy

1Load your original on the glass or into the ADF.

2Press Quality until the green light in front of the desired quality is lit.

3Press Start Copy - Black or Start Copy - Color.

You can reduce or enlarge a copy of an original with the Reduce/Enlarge button or the Special Features buttons. This section explains the Reduce/ Enlarge features only.

For more information about Special Features options, see perform special copy jobs on page 19 for information about using Fit to Page, Which Size?, Poster, 2 on 1, Margin Shift, or Mirror.

16 use copier features