HP XP24000 Example of a Spreadsheet, Structure and Identifier of Parameters UnitePathGroup Tag

Table 27 Structure and Identifier of Parameters (UnitePathGroup Tag)

Layer	Identifier	Content	Description
The first layer	None	Information about the path	This layer is required.
		group to which you want to
		move an external volume.

The second layer	+,	Information about the path
		group that you want to
		change.

Specifies one row for each alternate path group.

External volumes in two or more path groups can be moved to one path group by specifying two or more path groups.

Table 28 (page 117) shows the parameters that can be set for the UnitePathGroup tag. Table 28 UnitePathGroup Tag Parameters

Layer	Column in	Parameter	Setting	Range of Values	Number of
	Spreadsheet				Characters
The first layer			Information about the path group to which you want to move
			an external volume.
	A	PathGroup	Path group	0 to 63231	5 decimal digits or
			number.		fewer
The second layer			Information about the path group that you want to change.
	A	+	Identifier.	N/A	N/A
	B	TargetPathGroup	Path group	0 to 63231	5 decimal digits or
			number.		less

Example of a Spreadsheet

This section shows an example of a spreadsheet that can be used for mapping an external volume in the following configuration:

•An external volume is configured as follows:

◦Map the volume to which 0001 is configured as a LUN that can be discovered through the primary path.

◦Use 1 for a path group number.

◦Configure E16384-4095 for an external volume group (ExG).

•Two cross-subsystem paths are configured as follows:

◦The primary path

Port number on the local storage system: 1A

WWN on the external storage system: 60060E8004F81370

◦The alternate path

Port number on the local storage system: 1B

WWN on the external storage system: 60060E8004F81371

•Attributes of an external volume are configured as follows:

◦Emulation type: OPEN-V

◦Cache mode: Enable

Example of a Spreadsheet 117