C Adjusting the Volume Capacities for Pairs
When you create a pair, the capacity of an
For A, B, and C in the following description, see Figure 47 (page 156).
To adjust the capacity of the storage system volume to create a pair (if you want to use an external volume as
1.Map the external volume (A) as an internal volume (B) of the local storage system. Make sure that the emulation type of the volume is
2.Select the storage system volume (C) which has the same capacity as the mapped external volume (B), or which has the bigger capacity than the mapped external volume (B). The emulation type of the volume (C) has to be
3.If you select the storage system volume (C) that has a bigger capacity than the mapped external volume (B), make the CV that has the same capacity as the mapped external volume (B) out of the storage system volume (C) using the VLL function. For the VLL function, see the HP StorageWorks XP24000/XP20000 Virtual LVI/LUN (VLL) and Volume Shredder User Guide.
NOTE:
•When you make the CV that has the same capacity as the mapped external volume (B) using the VLL function, make the capacity of CV according to the Blocks capacity that is displayed in the Capacity column on the LDEV Information dialog box of XP External Storage (see (page 85)).
•To create an XP Continuous Access pair with an XP1024/XP128 Disk Array or Lightning 9900C series storage system volume, you may not be able to create a CV that has the same capacity as the mapped external volume (B) since the VLL function does not allow you to specify the capacity in Blocks. In this case, you cannot create an XP Continuous Access pair.
4.Create a pair.
Figure 47 Copying Data from an External Storage System (Using an External Volume as the P-VOL)
For A, B, and C in the following description, see Figure 48 (page 157).
To adjust the capacity of the external volume to create a pair (if you want to set an external volume as