Roberts Gorden BH-200, BH-60 Major Components, Stainless Steel, Burner Tube, Reflector End Cap

		SECTION 5: MAJOR COMPONENTS
SECTION 5: MAJOR COMPONENTS
FIGURE 13: Major Component Descriptions
	Burner with Tube Gasket	Reflector (Aluminum or
	Must be installed with the	Stainless Steel)
	flame observation window	Alternate overlap as shown on
	facing down.	overview and on Page 17,
		Figure 16. Minimum overlap is
		6'' (16 cm).

Burner Tube	Tube
Supplied in 10' (3 m) lengths.	Hot rolled or heat treated
Burner tube is always the first	aluminized tube supplied in
tube after the burner.	10' (3 m) lengths.

Tube and Reflector Hanger	Coupling Assembly with Lock
with Clamp Package
Position this hanger no more
than 4” (10 cm) away from the
burner.	Reflector End Cap
	Punch out center section to
	accommodate tube.
Tube and Reflector Hanger
Suspend system from these
hangers.

Reflector Support Strap & Wire Form

Flex Gas Line with

Shut Off Cock

Vent Adapter

Turbulator

Turbulator must be installed in the last standard section of tube. Turbulator is not required on the BH-125/150/175/200. For installation, see Page 21, Step 6.4

11 of 59