91-5387-30-00_ATT1460_R1 2003.3.27 10:21 AM Page 44
TELEPHONE OPERATION
PROBLEM
If you lose a call after changing channels:
SOLUTION
You were probably almost out of range. Move closer to the base before changing channels. Before placing another call,set the handset in the base for at least 15 seconds.
PROBLEM | SOLUTION |
If you are unable | If you have dial pulse (rotary) service, |
to operate special | follow the directions under “Temporary |
telephone services | Tone Dialing”in the TELEPHONE |
or other equipment | OPERATION section of this manual. |
requiring touch tone |
|
signals: |
|
|
|
PROBLEM | SOLUTION |
If messages are | • If a caller leaves a very long message, |
incomplete: | part of it may be lost when the system |
| disconnects the call after four minutes. |
| • If the caller pauses for more than seven |
| seconds,the system stops recording and |
| disconnects the call. |
| • If the system’s memory becomes full |
| during a message,the system stops |
| recording and disconnects the call. |
|
|
PROBLEM | SOLUTION |
If you have difficulty | Check the volume setting. |
hearing messages: |
|
|
|
44