HP 100B manual Computer Setup-Security

Computer Setup—Security

NOTE: Support for specific Computer Setup options may vary depending on the hardware configuration.

Table 2-4Computer Setup—Security

Option	Description
Setup Password	Allows you to set and enable a setup (administrator) password.
	NOTE: If the setup password is set, it is required to change Computer Setup options, flash the
	ROM, and make changes to certain plug and play settings under Windows.
	See the Desktop Management Guide for more information.
Power-On Password	Allows you to set and enable a power-on password. The power-on password prompt appears
	after a power cycle. If the user does not enter the correct power-on password, the unit will not
	boot.
	NOTE: This password does not appear on warm boots , such as Ctrl+Alt+Delete or Restart
	from Windows, unless enabled in Password Options (see below).
	See the Desktop Management Guide for more information.
Device Security	Allows you to set Device Available/Device Hidden for:
	●	System audio
	● Network controllers (some models)
	●	SATA0
	●	SATA1
USB Security	Allows you to enable or disable groups of USB ports or individual USB ports:
	●	Front USB Ports
		◦	USB Port 11
		◦	USB Port 13
	●	Rear USB Ports
		◦	USB Port 0
		◦	USB Port 1
		◦	USB Port 4
		◦	USB Port 9
	●	Accessory USB Ports
		◦	USB Port 3
		◦	USB Port 12
Slot Security	Allows you to disable or enable the mini card slot
Network Service Boot	Enables/disables the computer’s ability to boot from an operating system installed on a network
	server.

Computer Setup (F10) Utilities 7