HP 100B manual Disconnect the three cables from the board

6.Disconnect the three cables from the board (2).

NOTE: Be careful not to damage the cables when disconnecting them from the board. Do not pull on the wires.

Figure 6-42Removing the inverter board

7.Remove the inverter board from the computer. To remove the inverter board:

1.Prepare the computer for disassembly (see Preparing to Disassemble the Computer on page 26).

2.Remove the rear cover (see Rear Cover on page 27).

3.Remove the optical drive (see Optical Drive on page 33).

4.Remove the optical drive bracket (see Optical Drive Bracket on page 56).

5.Remove the tape that secures the cable to the computer.

58 Chapter 6 Removal and Replacement Procedures All-in One (AIO) Chassis