HP 2175xi, 2175v manual Hp psc 2170 series

chapter 3

For best results, adjust the paper settings each time you change paper types or paper sizes. For more information, see set the paper type on page 14.

to load the paper tray

1Remove the output tray, and slide the paper-width and paper-length guides to their outermost positions.

Note: Diagrams stamped on the output tray provide tips for installing print cartridges. The location of the Support Web site for HP PSC products, www.hp.com/support, is also provided.

2Tap the stack on a flat surface to align the edges of the paper, and then check the paper for the following:

–Make sure it is free of rips, dust, wrinkles, and curled or bent edges.

–Make sure all the paper in the stack is the same size and type, unless you are working with photo paper.

3Insert paper into the paper tray print-side down until it stops. If you are using letterhead, insert the top of the page first.

Be careful not to use too much or too little paper. Check that the stack of paper contains several sheets but is no higher than the top of the paper- length guide.

4Slide the paper-width and paper-length guides in until they stop at the edges of the paper. Make sure that the paper stack lies flat in the paper tray and fits under the tab of the paper-length guide.

5Replace the output tray.

10 hp psc 2170 series