HP 2170, 2175xi, 2175v manual Load 4 x 6 inch photo paper, Load postcards or hagaki cards

chapter 3

load 4 x 6 inch photo paper

Following is the procedure for loading 4-by-6 inch (10-by-15 cm) photo paper into your HP PSC.

1Remove all paper from the paper tray, and then slide a stack of photo paper into the tray until it stops.

Make sure the print side (glossy) faces down.

If the photo paper you are using has perforated tabs, load the photo paper so that the tabs are closest to you. Refer to the icons stamped on the input that indicate how tabbed media should be loaded.

2Adjust the paper-width guide against the stack of photo paper, and then slide the paper-length guide in until it stops.

Make sure the photo paper fits within the tray (do not overload it).

Note: Make sure you set the paper type and paper size before printing. See set the paper type on page 14 and set the paper size on page 14.

load postcards or hagaki cards

Following is the procedure for loading postcards or hagaki cards.

1Remove all paper from the paper tray, and then slide a stack of cards into the tray until they stop.

Make sure the print side faces down.

2Adjust the paper-width guide against the cards, and then slide the paper- length guide in until it stops.

Make sure the cards fit within the tray (do not overload it).

12 hp psc 2170 series