United States Stove 22AF owner manual Blower & Component Assembly FIG

BLOWER & COMPONENT ASSEMBLY - FIG. 9

1.Attach the Fan Limit Control Bracket to the rear of the furnace with four(4) of the #10 x 1/2 Tek screws provided in the parts bag.

2.Install the Honeywell Limit Control (1) to the bracket with two(2) of the #10 x 1/2 Tek screws provided in the parts bag.

3.Attach the Junction Box(2) to the Junction Box Bracket using two(2) #10 x 1/2 Tek screws. Then Mount the bracket to the rear of the furnace with four(4) #10 x 1/2 Tek screws. Also Attach the Conduit from the Limit Control to the Junction Box.

4.Install the five(5) Clip Nuts to the back of the furnace. Install the Blower(3) and Blower Gasket(4) to the furnace using the 1/4-20 x 3/4 bolts provided in the parts bag. Attach the remaining piece of Conduit from the junction box to the Blower. Use the Wiring Diagram on the following page to wire the assembly.

5.Reattach the junction box cover.

CLIP NUTS

LIMIT CONTROL

MOUNTING

BRACKET 1

JUNCTION BOX

MOUNTING

BRACKET

CONDUIT

2

CONDUIT 3

4

•DRAWINGS FOR ILLUSTRATION PURPOSES ONLY• 13