Through the ROOF/CEILING Installation

Installation

THROUGH THE WALL INSTALLATION (RECOMMENDED INSTALLATION)

To vent the unit through the wall, connect the pipe adapter to the exhaust motor adapter. If the exhaust adapter is at least 18-inches above ground level, a straight section of pellet vent pipe can be used through the wall.

Your King/Ashley dealer should be able to provide you with a kit that will handle most of this installation, which will include a wall thimble that will allow the proper clearance through a combustible wall. Once outside the structure, a 3-inch clearance should be maintained from the outside wall and a clean out tee should be placed on the pipe with a 90-degree turn away from the house. At this point, a 3-foot (minimum) section of pipe should be added with a horizontal cap, which would complete the installation (see FIGURE 7).

	A support bracket should be placed just below the
	termination cap or one every 4-feet to make the system
	more stable. If you live in an area that has heavy snowfall,
	it is recommended that the installation be taller than 3-feet
	to get above the snowdrift line. This same installation can
	be used if your stove is below ground level by simply adding
	the clean-out section and vertical pipe inside until ground
	level is reached. With this installation you have to be aware
	of the snowdrift line, dead grass, and leaves. We
	recommend a 3-foot minimum vertical rise on the inside	FIGURE 7
	or outside of the house.	FIGURE 7
	or outside of the house.	TYPICAL THROUGH THE WALL INSTALLATION
		TYPICAL THROUGH THE WALL INSTALLATION

The “through the wall” installation is the least expensive and simplest installation. Never terminate the end vent under a deck, in an alcove, under a window, or between two windows. We recommend Simpson Dura-Vent®or Metal-Fab®kits.

When venting the stove through the ceiling, the pipe is connected the same as through the wall, except the clean-out tee is always on the inside of the house, and a 3-inch adapter is added before the clean-out tee.

You must use the proper ceiling support flanges and roof flashing (supplied by the pipe manufacturer; follow the pipe manufacturer’s directions). It is important to note that if your vertical run of pipe is more than 15-feet, the pellet vent pipe size should be increased to 4-inches in diameter.

Do not exceed more than 4-feet of pipe on a horizontal run and use as few elbows as possible. If an offset is required, it is better to install 45-degree elbows rather than 90-degree elbows.

USSC