Lochinvar SPS0250 Faults, causes and rectification, Pump doesn’t run when power is switched on

Page 15

SL-PS Installation & Operation Manual

10 Faults, causes and rectification

Pump doesn’t run when power is switched on :

Check solar control unit for correct settings and tight wire connections.

Check fuses.

Check pump voltage, refer to the pump rating plate for requirements.

Motor blocked:

Close shut-off instruments upstream and downstream of pump at high liquid temperatures and system pressures. Allow pump to cool first.

Fully unscrew bleed screw and check ease of movement of pump rotor by turning the slotted shaft end with a screwdriver; use force to turn if necessary.

Pump Noise:

In the event of cavitation caused by insufficient inlet pressure, increase primary system pressure within allowable range.

Check speed setting.

If the fault cannot be rectified, please contact your nearest

Lochinvar/TiSUN customer service representative.

15

Image 15
Contents Solar Pump Station Installation and Operation ManualContents General Information Technical documentation Installation kitSolar Station Solar Control unitInstallation, connection lines to tank and collector Installing the solar stationInstalling the solar station on a wall Installing the relief valveTechnology, installation and commissioning Flat seal screw connectionsOperation, multi-function ball valve and check valve Filling, flushing and bleeding Commissioning the solar systemSPS0250 Pressure loss and residual delivery heightVFS flow sensor VFS 1-12 output signal flowDesignation SPS0250 / SPS0500 SPS1000 Technical data for solar stationDesignation SPS0250 / SPS0500 SPS1000 SPS0250/ SPS0500 Component breakdownSPS1000 Clamp ring screw connections ServiceDraining the system Air separatorPump Noise Faults, causes and rectificationPump doesn’t run when power is switched on Motor blockedRevision Notes Revision a ECO C06520 initial release