Lochinvar 150 - 500 service manual Parameter table, Whr

Service Manual

1Service

Parameter table

Table 1D This table lists SMART SYSTEM control module parameters and where to access them

GENERAL

MENU	SUB ITEM	DESCRIPTION	SEE	USER ACCESS		INSTALLER ACCESS
			PAGE	DISPLAY	MODIFY	DISPLAY	MODIFY
	1	Boiler Model	13	Yes	No	Yes	No
	2	User Code	13	Yes	Yes	Yes	Yes
	3	Date and Time	13	Yes	Yes	Yes	Yes
A
	4	Software Version	13	Yes	No	Yes	No
	5	Temperature Units	13	Yes	Yes	Yes	Yes
	6	Night Setback Temperature	13	Yes	Yes	Yes	Yes
	7	Night Setback Times	13	Yes	Yes	Yes	Yes

DATA	LOGGING		1	Total Hrs. Run	13	Yes	No	Yes	No
		C
			2	Ignition Attempts	13	Yes	No	Yes	No
			3	Show Last 10 Errors	13	Yes	No	Yes	No
FUNCTIONS
			1	Reset Last 10 Errors	13	No	No	Yes	Yes
		D
			2	Service Mode Delay	13	No	No	Yes	Yes
WHR	SETTINGS
		E	3	Tank Set Point	14	Yes	Yes	Yes	Yes
			2	Control Source (Thermostat, BMS,	14	No	No	Yes	Yes
				and Cascade)
CONTROL
	MODES		3	Cascade Address	14	No	No	Yes	Yes
		H
			4	Max. Cascade Set Point - Not Used	14	No	No	Yes	Yes
			5	Cascade Offset - Not Used	14	No	No	Yes	Yes
			6	Cascade Off-On Differential - Not	14	No	No	Yes	Yes
				Used

CIRCULATION

SERVICE

PUMPS
	I	3	WHR Pump Delay	15	No	No	Yes	Yes
NOTIFICATION
		1	Service Notification in Month	15	No	No	Yes	Yes
		2	Service Notification Running Hours	15	No	No	Yes	Yes
	J
		3	Service Notification Cycles	15	No	No	Yes	Yes
		4	Reset Service Notification Counter	15	No	No	Yes	Yes

NOTICE

The parameters for Building Management System operation are not listed in this table. They are only accessible using the PC interface software. See separate documentation for access information. See page 14 of this manual for a brief discussion.

12