ASRock Version 1.0 manual CPU Installation

Page 13

2.3 CPU Installation

For the installation of Intel 775-LAND CPU, please follow the steps below.

775-Pin Socket Overview

Before you insert the 775-LAND CPU into the socket, please check if the CPU surface is unclean or if there is any bent pin on the socket. Do not force to insert the CPU into the socket if above situation is found. Otherwise, the CPU will be seriously damaged.

Step 1. Open the socket:

Step 1-1. Disengaging the lever by depressing down and out on the hook to clear retention tab.

Step 1-2. Rotate the load lever to fully open po- sition at approximately 135 degrees.

Step 1-3. Rotate the load plate to fully open po- sition at approximately 100 degrees.

Step 2. Insert the 775-LAND CPU:

Step 2-1. Hold the CPU by the edges where are marked with black lines.

Step 2-2. Orient the CPU with IHS (Integrated Heat Sink) up. Locate Pin1 and the two orientation key notches.

blackline

blackline

Pin1

 

 

 

 

 

Pin1

 

 

 

 

alignment key

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

alignment key

 

 

 

 

 

orientation

orientation

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

key notch

key notch

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

775-Pin Socket

 

 

 

 

775-LAND CPU

 

 

 

 

 

 

 

13

Image 13
Contents 4Core1600-D800 Disclaimer Copyright NoticeContents Software Support Introduction Package ContentsSpecifications Bios Feature ConnectorSupport CD HardwarePage CPU ATXPWR1 Motherboard LayoutFor Windows XP ASRock 6CH I/OScrew Holes Pre-installation PrecautionsCPU Installation Page Installation of CPU Fan and Heatsink Installing a Dimm Installation of Memory Modules DimmExpansion Slots PCI and PCI Express Slots Installing an expansion cardPS2USBPWR1 Jumpers SetupIDE1 Onboard Headers and ConnectorsUSB 2.0 Headers Chassis Speaker Header ATX Power Connector Western Digital Sataii Hard Disk Setup GuideUntied Overclocking Technology Driver Installation GuideBios Menu Bar Main Screen Navigation KeysAdvanced Screen CPU Configuration Ratio Actual Value Ratio StatusEnhance Halt State Max Cpuid Value LimitChipset Configuration Dvmt Mode Select Internal Graphics Mode SelectDram RAS# Precharge Dram RAS# Activate to PrechargeDram Voltage Dram Rcomp SettingNB Core Voltage VTT VoltageAcpi Configuration ATA/IDE Configuration IDE ConfigurationAcpi Hpet Table Combined OptionLBA/Large Mode IDE Device ConfigurationPIO Mode Block Multi-Sector TransferPCIPnP Configuration Super IO Configuration Floppy ConfigurationOnBoard Floppy Controller Serial Port AddressECP Mode DMA Channel Parallel Port ModeParallel Port Address EPP VersionUSB Controller USB Controller EnabledUSB 2.0 Support Legacy USB SupportHardware Health Event Monitoring Screen Target CPU TemperatureCPU Quiet Fan Target Fan SpeedBoot Settings Configuration Boot ScreenMain Advanced Monitor Security ExitBoot From Onboard LAN Boot Settings ConfigurationBoot Up Num-Lock Security ScreenExit Screen Load Optimal DefaultsSave Changes and Exit Discard Changes and ExitSupport CD Information Install Operating SystemRunning The Support CD Drivers Menu