ASRock Version 1.0 Boot Screen, Main Advanced Monitor, Security Exit, Boot Settings Configuration

Page 40

3.5 Boot Screen

In this section, it will display the available devices on your system for you to config- ure the boot settings and the boot priority.

BIOS SETUP UTILITY

Main

Advanced

H/W Monitor

Boot

Security Exit

Boot Settings

Boot Settings Configuration

1st Boot Device	[1st Floppy Device]
2nd Boot Device	[HDD: PM - HDS722580VL]
3rd Boot Device	[CD / DVD: 3S - CD - ROM C]
4th Boot Device	[USB]
Hard Disk Drives
Removable Drives
CD/DVD Drives

Configure Settings during System Boot.

	Select Screen
	Select Item
Enter	Go to Sub Screen
F1	General Help
F9	Load Defaults
F10	Save and Exit
ESC	Exit

v02.54 (C) Copyright 1985-2005, American Megatrends, Inc.

40

Image 40

Contents 4Core1600-D800 Copyright Notice DisclaimerContents Software Support Package Contents IntroductionSpecifications Connector Bios FeatureSupport CD HardwarePage CPU Motherboard Layout ATXPWR1ASRock 6CH I/O For Windows XPPre-installation Precautions Screw HolesCPU Installation Page Installation of CPU Fan and Heatsink Installation of Memory Modules Dimm Installing a DimmInstalling an expansion card Expansion Slots PCI and PCI Express SlotsJumpers Setup PS2USBPWR1Onboard Headers and Connectors IDE1USB 2.0 Headers Chassis Speaker Header ATX Power Connector Sataii Hard Disk Setup Guide Western DigitalDriver Installation Guide Untied Overclocking TechnologyBios Menu Bar Main Screen Navigation KeysAdvanced Screen CPU Configuration Ratio Status Ratio Actual ValueEnhance Halt State Max Cpuid Value LimitChipset Configuration Internal Graphics Mode Select Dvmt Mode SelectDram RAS# Precharge Dram RAS# Activate to PrechargeDram Rcomp Setting Dram VoltageNB Core Voltage VTT VoltageAcpi Configuration IDE Configuration ATA/IDE ConfigurationAcpi Hpet Table Combined OptionIDE Device Configuration LBA/Large ModePIO Mode Block Multi-Sector TransferPCIPnP Configuration Floppy Configuration Super IO ConfigurationOnBoard Floppy Controller Serial Port AddressParallel Port Mode ECP Mode DMA ChannelParallel Port Address EPP VersionUSB Controller Enabled USB ControllerUSB 2.0 Support Legacy USB SupportTarget CPU Temperature Hardware Health Event Monitoring ScreenCPU Quiet Fan Target Fan SpeedBoot Screen Boot Settings ConfigurationMain Advanced Monitor Security ExitBoot Settings Configuration Boot From Onboard LANBoot Up Num-Lock Security ScreenLoad Optimal Defaults Exit ScreenSave Changes and Exit Discard Changes and ExitInstall Operating System Support CD InformationRunning The Support CD Drivers Menu