2.8 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place jumper caps over these headers and connectors. Placing jumper caps over the headers and connectors will cause permanent damage of the motherboard!
FDD connector |
|
|
|
| |
(see p.10 No. 20) | Pin1 | FLOPPY1 |
| ||
|
|
the
Note: Make sure the
Primary IDE connector (Blue)
| PIN1 | IDE1 |
|
| |
connect the blue end |
| connect the black end |
to the motherboard |
| to the IDE devices |
Note: Please refer to the instruction of your IDE device vendor for the details.
Serial ATAII Connectors
(SATAII_1: see | p.10, No. 14) |
| |
SATAII_3 | |||
(SATAII_2: see | p.10, No. 12) | ||
| |||
(SATAII_3: see | p.10, No. 13) |
| |
| |||
SATAII_1 | |||
(SATAII_4: see | p.10, No. 11) | ||
|
SATAII_4
SATAII_2
These four Serial ATAII (SATAII) connectors support SATA data cables for internal storage devices. The current SATAII interface allows up to 3.0 Gb/s data transfer rate.
Serial ATA (SATA) | Either end of the SATA data cable |
Data Cable | can be connected to the SATA / |
(Optional) | SATAII hard disk or the SATAII |
| connector on this motherboard. |
Serial ATA (SATA)
Power Cable
(Optional) |
|
| |
connect to the SATA | |||
| |||
| HDD power connector | ||
connect to the power supply
Please connect the black end of SATA power cable to the power connector on each drive. Then connect the white end of SATA power cable to the power connector of the power supply.
19