ASRock Version 1.0 manual Boot Settings Configuration, Security Screen, Boot From Onboard LAN

Page 41

3.5.1 Boot Settings Configuration

BIOS SETUP UTILITY

Boot

Boot Settings Configuration

Boot From Onboard LAN

[Disabled]

Bootup Num-Lock

[On]

To enable or disable the boot from onboard LAN feature.

Select Screen

Select Item

+- Change Option

F1 General Help

F9 Load Defaults

F10 Save and Exit ESC Exit

v02.54 (C) Copyright 1985-2005, American Megatrends, Inc.

Boot From Onboard LAN

Use this item to enable or disable the Boot From Onboard LAN feature.

Boot Up Num-Lock

If this item is set to [On], it will automatically activate the Numeric Lock function after boot-up.

3.6 Security Screen

In this section, you may set or change the supervisor/user password for the system. For the user password, you may also clear it.

BIOS SETUP UTILITY

Main

Advanced

H/W Monitor

Boot

Security

Exit

Security Settings

Supervisor Password

: Not Installed

User Password

: Not Installed

Change Supervisor Password

Change User Password

Install or Change the password.

 

Select Screen

 

Select Item

Enter

Change

F1

General Help

F9

Load Defaults

F10

Save and Exit

ESC

Exit

v02.54 (C) Copyright 1985-2005, American Megatrends, Inc.

41

Image 41
Contents 4Core1600-D800 Disclaimer Copyright NoticeContents Software Support Introduction Package ContentsSpecifications Bios Feature ConnectorSupport CD HardwarePage CPU ATXPWR1 Motherboard LayoutFor Windows XP ASRock 6CH I/OScrew Holes Pre-installation PrecautionsCPU Installation Page Installation of CPU Fan and Heatsink Installing a Dimm Installation of Memory Modules DimmExpansion Slots PCI and PCI Express Slots Installing an expansion cardPS2USBPWR1 Jumpers SetupIDE1 Onboard Headers and ConnectorsUSB 2.0 Headers Chassis Speaker Header ATX Power Connector Western Digital Sataii Hard Disk Setup GuideUntied Overclocking Technology Driver Installation GuideBios Menu Bar Advanced Screen Navigation KeysMain Screen CPU Configuration Ratio Actual Value Ratio StatusEnhance Halt State Max Cpuid Value LimitChipset Configuration Dvmt Mode Select Internal Graphics Mode SelectDram RAS# Precharge Dram RAS# Activate to PrechargeDram Voltage Dram Rcomp SettingNB Core Voltage VTT VoltageAcpi Configuration ATA/IDE Configuration IDE ConfigurationAcpi Hpet Table Combined OptionLBA/Large Mode IDE Device ConfigurationPIO Mode Block Multi-Sector TransferPCIPnP Configuration Super IO Configuration Floppy ConfigurationOnBoard Floppy Controller Serial Port AddressECP Mode DMA Channel Parallel Port ModeParallel Port Address EPP VersionUSB Controller USB Controller EnabledUSB 2.0 Support Legacy USB SupportHardware Health Event Monitoring Screen Target CPU TemperatureCPU Quiet Fan Target Fan SpeedBoot Settings Configuration Boot ScreenMain Advanced Monitor Security ExitBoot From Onboard LAN Boot Settings ConfigurationBoot Up Num-Lock Security ScreenExit Screen Load Optimal DefaultsSave Changes and Exit Discard Changes and ExitSupport CD Information Install Operating SystemRunning The Support CD Drivers Menu