ASRock K10N78hSLI-GLAN manual Jumpers Setup, PS2USBPW1

2 . 6 Jumpers Setup

The illustration shows how jumpers are setup. When the jumper cap is placed on pins, the jumper is “Short”. If no jumper cap is placed on pins, the jumper is “Open”. The illustration shows a 3-pin jumper whose pin1 and

pin2 are “Short” when jumper cap is placed on these 2 pins.

Jumper		Setting
PS2_USB_PW1	1_2	2_3	Short pin2, pin3 to enable
(see p.11, No. 1)	+5V	+5VSB	+5VSB (standby) for PS/2 or
			USB wake up events.

Note: To select +5VSB, it requires 2 Amp and higher standby current provided by power supply.

Clear CMOS Jumper	1_2	2_3
(CLRCMOS1)
(see p.11, No. 9)	Default	Clear CMOS

Note: CLRCMOS1 allows you to clear the data in CMOS. The data in CMOS includes system setup information such as system password, date, time, and system setup parameters. To clear and reset the system parameters to default setup, please turn off the computer and unplug the power cord from the power supply. After waiting for 15 seconds, use a jumper cap to short pin2 and pin3 on CLRCMOS1 for 5 seconds. However, please do not clear the CMOS right after you update the BIOS. If you need to clear the CMOS when you just finish updating the BIOS, you must boot up the system first, and then shut it down before you do the clear-CMOS action.

20