4
ThermalFlo Heat Pump Dimensions
38.7" | 30.7" |
A
PRODUCT SPEC
LABEL
|
|
|
|
|
| 11.25" |
|
|
|
|
|
| 9.25" |
|
|
|
|
|
| 4.5" |
|
|
| MODEL NUMBER |
| ||
| 500 | 700 | 900 | 1200 | 1200C | 1200R H/C |
Dimension "A" | 33.5” | 33.5” | 41.5” | 41.5” | 41.5” | 41.5” |
ThermalFlo™ HP
6.5"18.0"
.5"
32.0"
Figure 1.
Correct installation is required to assure safe operation. The requirements for Pentair Water heat pumps includethefollowing:
•Dimensionsforcriticalconnections.
•Fieldassembly(ifrequired).
•Appropriate site location and clearances. (See pages
•Proper electrical wiring. (See pages vi and
•Adequate water flow. (See page vi.)
This manual provides the information needed to meet these requirements. Review all application and installation procedures completely before continuing the installation.
Location
CAUTION — When pool equipment is located below the pool surface, a leak from any component can cause large scale water loss or flooding. Pentair Water Pool and Spa, Inc. cannot be responsible for such water loss or flooding which may cause damage to the product.
Avoid placing the heat pump in locations where it can cause damage by water or condensate leakage. If this is not possible, provide a suitable drain pan to catch and divert any leakage.
ThermalFlo Installation and User’s Guide