5 Service Parts Replacement
A. Glass Replacement | B. Snap Disc Replacement |
|
1.Ensure that the fire is out and the appliance is cool to the touch.
2.Protect a table or counter top with padding or towels. Protect your hands and wear gloves to prevent injury.
3.Remove the door with the broken glass by lifting the door up and off of the hinges.
4.Lay door face down on a table or counter making sure the handle hangs over the edge so the door lays flat, on a soft surface.
5.Remove the screws from each glass retainer and remove the glass. (If screws are difficult to remove, soak with penetrating oil first).
6.Center the glass with edges evenly overlapping the open- ing in the door, (i.e. same space top and bottom, left and right sides).
7.Replace the glass retainers. Be careful not to cross thread the screws.
8.Tighten each retainer just a few turns until each is se- cured. Check again for centering of glass in door frame. Continue to tighten each retainer alternately, a few turns at a time, until the glass is secure. DO NOT OVERTIGHTEN - can cause glass to break.
9.Replace the door on the appliance.
WARNING! Risk of Fire or Injury!
Use only glass that is specified in the manual, DO NOT replace with any other material. Glass breakage will occur.
CAUTION!
Handle glass with care.
•Inspect the gasket to ensure it is undamaged.
•Do NOT strike, slam or scratch glass.
•Do NOT operate appliance with glass & door assembly removed.
•Do NOT operate with glass cracked, broken or scratched.
This appliance is equipped with ceramic super
1.Disconnect power supply. Locate the snap disc bracket assembly at the bottom left rear corner of the appliance.
Figure 21.1.
2.A magnet holds the bracket to the appliance. Pull the bracket down away from the appliance to expose the snap disc.
3.Pull the snap disc and spade connectors up and out of bracket as shown in Figure 21.2.
4.Using a Phillips head screw driver, remove the 2 screws from the snap disc and then remove the snap disc from the spade connectors. Replace with new snap disc and
5.Push the snap disc and spade connectors back inside bracket and
Snap Disc Location
Figure 21.1
Snap Disc
Magnet
Spade
Connectors
Figure 21.2
Heatilator • | 21 |