Heath Zenith 598-1041-04 manual Troubleshooting Guide, No Service Parts Available for this Product

TROUBLESHOOTING GUIDE

If you experience a problem with your lantern, follow this guide before returning it to the

retailer.

SYMPTOM	POSSIBLE CAUSE
Light will not	1. Light switch is turned off.
come on.	2. Bulb is loose or burned
		out.
	3.	Fuse is blown or circuit
		breaker is turned off.
	4.	Daylight turn-off is in ef-
		fect (recheck after dark).
	5.	Incorrect circuit wiring, if
		this is a new installation.
Light comes	1.	Light Control may be in-
on in day-		stalled in a relatively dark
light.		location.
	2.	Light Control is in Test.
		(Set control switch to an
		ON-TIME position).
Light comes	1.	Light Control may be sens-
on for no ap-		ing small animals or
parent rea-		automobile traffic (Reduce
son.		sensitivity).
	2.	Sensitivity is set too high.
		(Reduce sensitivity.)

SYMPTOM		POSSIBLE CAUSE
Light	stays	1.	The sensor may be picking
on continu-			up a heat source like an air
ously.			vent, dryer vent, or brightly-
			painted heat-reflective
			surface.	(Reduce
			sensitivity).
		2.	Light control is in Manual
			Mode. (Switch to Auto.)
		3.	Light control is in Dual
			Brite™ mode.
Light flashes		1. Sensor is in the Test mode.
on and off.			(While in TEST mode, light
			only stays on for 5 seconds.)
		2. Heat being reflected from
			other objects	may be
			affecting the sensor. (Re-
			aim sensor.)
Light	does	1.	Nearby large, light-colored
not stay on in			objects reflecting light may
M a n u a l			trigger the shut-off feature.
mode.			Do not point other lights at
			the sensor.

No Service Parts Available for this Product

See your Canadian Tire retailer for warranty information.

598-1041-04 5