Pelco IS210 manual Important Safety Instructions

Page 4

Important Safety Instructions

1.Read these instructions.

2.Keep these instructions.

3.Heed all warnings.

4.Follow all instructions.

5.Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.

6.Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.

7.Only use attachments/accessories specified by the manufacturer.

8.Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.

9.Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

10.Installation should be done only by qualified personnel and conform to all local codes.

11.Unless the unit is specifically marked as a NEMA Type 3, 3R, 3S, 4, 4X, 6, or 6P enclosure, it is designed for indoor use only and it must not be installed where exposed to rain and moisture.

12.Use only installation methods and materials capable of supporting four times the maximum specified load.

13.Use stainless steel hardware to fasten the mount to outdoor surfaces.

14.To prevent damage from water leakage when installing a mount outdoors on a roof or wall, apply sealant around the bolt holes between the mount and mounting surface.

15.CAUTION: These servicing instructions are for use by qualified service personnel only. To reduce the risk of electric shock do not perform any servicing other that contained in the operating instructions unless you are qualified to do so.

16.Only use replacement parts recommended by Pelco. The product and/or manual may bear the following marks:

This symbol indicates that dangerous voltage constituting a risk of electric shock is present within this unit.

This symbol indicates that there are important operating and maintenance instructions in the literature accompanying this unit.

CAUTION:

RISK OF ELECTRIC SHOCK.

DO NOT OPEN.

4

C3428M-A (1/08)

Image 4
Contents IS210 Series Camclosure Page Contents Important Safety Instructions Regulatory Notices Radio and Television InterferenceParts List DescriptionInstallation Prepare Mounting SurfaceFixed Mounting Pattern Without Conduit Install BaseWith Conduit Removing the Wiring Plug Removing the Conduit Cover Adjust Position Reinstall Camera ModuleReplace Cover DN/CH Series Adjustments Switch SettingsSW4-1 Automatic Gain Control SW4-2 Backlight CompensationAuto Iris Level Adjustment Vertical Phase AdjustmentSW4-4 Flickerless SW4-5 Auto White Balance/Manual White BalanceAdjusting Vertical Phase Blemish DetectionDAY/NIGHT Operation DW/CW Series Wide Dynamic Range Adjustments SW1-1 Video FormatSW1-2 Line Sync SW1-3 Interlaced Scanning/Progressive ScanningSW1-4 Auto White Balance/Manual White Balance SW1-5 Fluorescent/GeneralSW1-6 General WDR/Maximum WDR SW1-7 Digital Slow ShutterSW1-8 Day/Night Operation DW models only Auto Iris Level Adjustment Service Connector Attaching the 2.5 mm Monaural Headphone PlugSpecifications GeneralProduct Warranty and Return Information ISO9001