Pelco IS210 manual Regulatory Notices, Radio and Television Interference

Page 5

REGULATORY NOTICES

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

RADIO AND TELEVISION INTERFERENCE

This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However there is no guarantee that the interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

You may also find helpful the following booklet, prepared by the FCC: “How to Identify and Resolve Radio-TV Interference Problems.” This booklet is available from the U.S. Government Printing Office, Washington D.C. 20402.

Changes and modifications not expressly approved by the manufacturer or registrant of this equipment can void your authority to operate this equipment under Federal Communications Commission’s rules.

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

C3428M-A (1/08)

5

Image 5
Contents IS210 Series Camclosure Page Contents Important Safety Instructions Radio and Television Interference Regulatory NoticesDescription Parts ListPrepare Mounting Surface InstallationFixed Mounting Pattern With Conduit Install BaseWithout Conduit Removing the Wiring Plug Removing the Conduit Cover Replace Cover Reinstall Camera ModuleAdjust Position Switch Settings DN/CH Series AdjustmentsSW4-1 Automatic Gain Control SW4-2 Backlight CompensationVertical Phase Adjustment Auto Iris Level AdjustmentSW4-4 Flickerless SW4-5 Auto White Balance/Manual White BalanceBlemish Detection Adjusting Vertical PhaseDAY/NIGHT Operation SW1-1 Video Format DW/CW Series Wide Dynamic Range AdjustmentsSW1-2 Line Sync SW1-3 Interlaced Scanning/Progressive ScanningSW1-5 Fluorescent/General SW1-4 Auto White Balance/Manual White BalanceSW1-6 General WDR/Maximum WDR SW1-7 Digital Slow ShutterSW1-8 Day/Night Operation DW models only Auto Iris Level Adjustment Attaching the 2.5 mm Monaural Headphone Plug Service ConnectorGeneral SpecificationsProduct Warranty and Return Information ISO9001